• ベストアンサー

起動時にスキャンディスクが自動で作動しこんなメッセージが出ます。

udragonの回答

  • ベストアンサー
  • udragon
  • ベストアンサー率40% (2/5)
回答No.2

私の例が役に立つか否かわかりませんが、ご質問の場合と似たような経験をしましたので、以下に述べておきます。 不具合になった発端:Fat32のファイルシステムをNTFSにコンバートしている途中にHDDに不具合があるのでコンバートが終了しなかったとのメッセージが出てシステムダウン。次に起動したときにはご質問の方と同様のエラーメッセージが出て、如何にしようともWindowsXPの起動が出来なくなった。 システム修復のためにやったこと:WindowsXPの再インストールを試みたが、インストール過程の中で行われるHDDのscandiskが、HDDの不具合のために終了できないとのメッセージが出て、それより先にインストールを進めることが出来ない。 修復に成功した作業内容:上記のような状況で困ってしまい、ともかくもHDDがどのようになっているか調べたいと思い、以前に使っていたWindows2000をインストールしたHDDを取り出して、これをfirst boot側に、不具合のあるHDDをsecond boot側に接続してWindows2000を起動しようとしたところ、second boot側のHDDに異常があるため修復をするとのメッセージが出て、システムがMBRの修復を行った。Windows2000を起動後、WindowsXPをインストールしたHDDのファイルを調べてみたが特に異常はない様であった。HDDを入れ替えて不具合のあったHDDをfirst boot側にしてWindowsXPを起動したところ、見事にシステムの回復が出来た。 以上のような経過で、結局MBRが破損していたことが原因とわかりました。 確定的なことはいえませんが、上記の事柄が何らかのお役に立てばと思い、投稿しました。

関連するQ&A

  • 起動ディスクを入れるとエラーが起きます

    起動ディスクを1~6を入れて6枚目を入れると 青画面になってこういうメッセージが出ます。 BIOSを更新した方がいいのでしょうか? 知識不足なので分かる方教えてください。 A problem has been detected and windows has been shut down to prevent damage to your computer. IF this is the first time you've seen this stop error screen, restart your computer.If this screen appears again, follow these steps: Check to be sure you have adequte disk space. If a driver is identified in the stop message, disable the driver or check with the manufacturer for driver updates. Try changing video adapters. Check with your hardware vendor for any BIOS updates.Disable BIOS memory options such as caching or shadwing.If you need to use Safe Mode to remove or disable components,restart your computer,press F8 to select Advanced Stratup Options,and then select Safe Mode. STOP:0x000007E(0xc0000005,0xF7768DCE,0xF7C7903C,0xF7C78038) acpi.sys - Address F7768DCE base at F7754000,DateStamp 41107d27

  • OSのインストール時に出るメッセージ

    既出トピックでしたらすみません。 先日新しいパソコン(OSなし)を購入しました。 インストールしようとしたところ、セットアップが始まった後に以下のメッセージが出てしまいます。 サポートセンターにも問い合わせましたが故障ではないとの返答でした。 勉強不足かもしれませんが、ご教授ください。 【以下メッセージ】 A problem has been detected and windows has been shut down to prerent damage to your computer. If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps: Check to be sure you have adequate disk space. If a driver is identified in the stop message, disable the driver or check with the manufacturer for driver updates. Try changing video adapters. Check with your hardware vendor for any BIOS updatet. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Option, and then select Safe Mode.

  • パソコン起動時にわからない英語だらけで動きません

    パソコン画面にこのような文字が出ました。移してみましたが、どのような意味でしょうか。深刻な気がしますが・・・ A problem has been deteeted and windows haabeen shut down to prevent damage to your computer. driver_1RQL_Not_Less_or_EQUL It this is the first time you've seen this stop error screen, restart your computer.If this screen appears again,follow these steps. check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any windows updates you might need. If problems continue, disable or remove any newly installed hardware or software. Disable Bios memory options such as caching or shadowing. If you need to use safe mode to remove or disable comonents,restart your computer,press F8 to select advanced start up options, and then select safe mode. Technical information stop ~? Begnning dump of physical memory 間違いの文字があるかもしれませんが、このような事が書かれてありました。 宜しくお願いします。

  • 起動ディスクでも起動が,,,

    こんばんわ WinXPHのSP2搭載の NECのVALUESTARのPC-VT5707Dなんですが 昨日まで正常に起動終了ができていったのに今朝立ち上げてみると 次のファイルが壊れているため起動できません C:?WINDOWS?SYSYTEM32?CONFIG?SYSTEM 以下省略 となりSP2のブートFDを使用して修復の準備に入ったのですが最後の6枚目のディスクを入れた途端に A problem has been detected and windows has been shut down to prevent damage to your computer, UNMOUNTABLE_BOOT_VOLUME If this is the first time you’ve seen this stop error screen, restart your computer. If this screen appears again, follow these: check to make sure any hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any windows updates you might need. If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Start up Options, and then select Safe Mode. Techical information: STOP0x000000ED(0x816A1998,0xC0000013,0x00000000,0x00000000) とでって回復コンソールすら起動できません。 因にセフーティーモードも起動できません。 なんとか中のデータは救出したいのですが何か方法はないでしょうか? またこの用に成った原因は何が有るのでしょうか? 勿論周辺機器などは新たに増設などはしておりません。 お忙しい中誠に申し訳ありませんが皆様のご意見をお聞かせ下さい。 長文になりましたが宜しくお願い致します。

  • xp proで起動ディスクで起動すると・・・

    XP PROで起動ディスクを起動すると6枚目のFDを読み終えると英語のエラーが出てきます。これはどう対処すればよいのでしょうか・・・。 A problem has been detected and windows has been shut down to prevent damege to your computer. If this is the first time you've seen this Stop error screen,restart your computer.if this screen appears again,follow these steps : Check for viruses on your computer.Remove any newly installed hard drives or hard drive controllers.Check your hard drive to make sure it is properly configured and terminated.Run CHKDSK /F to check for hard drive corruption,and then restart your computer. technical information: Stop:0*0000007B(0*F99DD63C,0*C0000034,0*00000000,0*00000000)

  • パソコン起動の途中で止まる。下記エラーメッセージが出ます window

    パソコン起動の途中で止まる。下記エラーメッセージが出ます windows xp サービスパック2 パソコン工房製 A problm has been detected and windows has been shut sown to prevent damage to your computer. If this the first time you've seen this error screen, restart your computer. If this screen appaers again, follow these steps: Check to be sure you have adequate disk space.If a driver is identified in the Stop message, disable the driver or check with the manufacturer for driver updates. Try changing video adapters. Cheak with your hardware vendor for any BIOS updates. Disable Bios memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Adovanced Startup Options, and then Select Safe Mode. Technical information: ***Stop: 0x0000008E (0xC0000005,0x805529E9,0xA98B98C,0x00000000) Beginning dump of physical memory physcal memory dump complete. Contact your system adoministrator or technical support group for further assistance. よろしくお願いします

  • エラーメッセージ

    ちょっと長くなりますがエラーメッセージを書くので対処方法を教えてください。 A problem has been detected and windows has been shut down to prevent damage to your computer. If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these stops. Check to be sure you have adequate disc space. If a drive is identified in the stop message, disable the driver or check with the manufacturer for driver updates. Try changing video adapters. Check with your hardware vendor for any Bios updates. disable BIOS memory options such as caching or shadowing. if you need to uses safe Mode to remove or disable components, restart your computer, prees F8 to select Advanced startup options, and the select safe mode. このメッセージが出て勝手にwindowsが再起動します。 何が原因でしょうか?

  • 操作途中で、電源が突然落ちてしまう

    WindowsXPを使っています。パソコンのメーカーはソーテックです。キーボードをたたいたり、マウスを動かしている最中に、電源が突然落ちてしまい、青地に白の文字で、次のような文章が出てきます。 A oroblem has been detected and windows has been shut down to prevent damage to your computer. If this is the first time you've seen this stop error screen,restart your computer. If this screen appears again, follow these steps: check to be sure you have adequate disk space. If a driver is identified in the stop message,disable the driver or check with the manufacturer for driver updates. Try changing video adapters. check with your hardware vender for any BIOS updates. Disable BIOS mjemory options such as cachinp or shadowing. If you need to use safe mode to remove or disable componennts, restart your select safe mode. 電源オプションは「常にオン」にしています。ADSLにつないでいます。Yahoo!BBです。 何をいじればいいか分からないので、是非教えてください。

  • XPが起動しない( 一一)

    PCを立ち上げようとすると、ブルー画面になり  a problem has been detected and windows has been shut down to prevent damage to your computer. if this is the first time you've seen this stop error screen restart your computer. if this screen appears again follow these steps: disable or uninstall any anti virus disk defragmentation or backup utilities. check your hard drive configuration and check for any updated drivers. run CHKDSK/f to check for hard drive configuration and then restart your computer. と出てくるのですが、どうすればいいのかさっぱり解りません。 PCにあまり詳しくないので(-"-) 誰かよきアドバイスを(>_<)

  • 起動しないのですが…どうすれば

    家に帰ってPCの電源を入れると、こんなメッセージがでました。 a problem has been detected and windows has been shut down to prevent damage to your computer. if this is the first time you've seen this stop error screen restart your computer. if this screen appears again follow these steps: disable or uninstall any anti-virus,disk defragmentation. or back up utilities. check your hard drive configuration. and check for any updated drivers, RUN CHKDSK/F to check for hard drive corruption,and then restart your computer. このような場合どうしたらいいのでしょう?