• ベストアンサー

誰か教えてください。。

誰か教えてください。。。 A student finds that it takes 38.78 mL of 0.1720 M NaOH to titrate 15.00 mL of sulfuric acid solution. Determine the molarity and percent mass of the sulfuric acid in the solution (you may assume that the density of the sulfuric acid solution is the same as pure water).

  • 化学
  • 回答数3
  • ありがとう数0

質問者が選んだベストアンサー

  • ベストアンサー
noname#160321
noname#160321
回答No.2

ある学生さんが15.00mLの硫酸溶液を滴定したら0.1720M(mol/L)の水酸化ナトリウム溶液が38.78mL必要でした。この硫酸溶液のモル濃度と質量パーセントを求めなさい。ただし、硫酸溶液の密度は純水と同じと仮定してよろしい。 Cmol/Lの硫酸では、 C×2×15.00=0.1720×38.78 さてCはいくら? 硫酸の式量98.08 では硫酸の質量はいくら? するとすぐ質量パーセントが出る。

その他の回答 (2)

  • nious
  • ベストアンサー率60% (372/610)
回答No.3

多分、これは削除対象でしょう。 硫酸(sulfuric acid)は2価の酸だから、問題の濃度をx(M)とすれば、 0.172*(38.78/1000)=2x*(15.00/1000)が成り立ちますぜ。 また重量%濃度は、題意から密度を1g/mlとして、100*98x/1000(%) でしょう。

noname#62864
noname#62864
回答No.1

何を教えて欲しいの? ちなみに、問題の丸投げは削除対象ですので、まさかその問題の答を教えて欲しいというわけではないと思いますが。

関連するQ&A

  • 訳が分かりません・・・

    To the solution is added dropwise a solution of 280 gm (1.9 moles) of 3,4-dimethylacetophenone in 150 ml of isopropanol at such a rate that the solution gently refluxes. 溶液に、イソプロパノールをゆっくりと還流するような速度で、150ml中の3,4-dimethylacetophenone(ジメチルラセトフェノール) 自分で訳していて良く分からなくなってしまいました。 また、化学実験書の To the solution is added って普通の訳みたいに、 溶液に加えられた。 と、このように受身形にして訳すほうが良いのでしょうか? 以上、2点よろしくお願いいたします。

  • この英文の和訳お願いします.

    The radius of the sphere should not affect the solution except that the companion solution in the integral kernel would vary with the radius. Also, it should be noted that the companion solution is a function of source point y. integral kernel という積分核っていったいなんなんでしょうか? お手数かもしれませんが,よろしくお願いします.

  • 細菌の密度

    ある論文で「Bacteria were harvested at the exponential growth phase and inoculated at a same starting density of 10の5乗 ml(-1乗) in a medium」 って書いてあったんですけど、この密度の細菌はどのようにして用意するんでしょうか?

  • 英訳してください

    Electrophilic substitution Electrophilic substitution in the highly activated phenol ring occurs under very mild conditions, and mononitration must be carried out with dilute aqueous nitric acid. The usual nitric acid-sulfuric acid mixture gives complex mixtures of polynitro compounds and oxidation products. Separation of o- and p-nitrophenol can be accomplished by taking advantage of the strong intramolecular hydrogen bonding, or chelation, in the ortho isomer. In the para isomer, the hydrogen bonding is inter-molecular, leading to association of the molecules in the liquid and much lower vapor pressure. On steam distillation of the mixture the ortho isomer is obtained in pure form in the distillate. The para isomer can then be isolated from the nonvolatile residue. [Procedure] In a 250-ml Erlenmeyer flask, place 10 ml of concentrated nitric acid and 35 ml of water. Weigh out 8.0 g of phenol ("loose crystals") in a 50-ml beaker. (CAUTION: Avoid contact with skin.) Add 2 ml of water and allow the mixture to liquefy. With a disposable pipet, add 1- to 2-ml portions of the phenol to the nitric acid and cool as necessary by swirling in a pan of cold water to keep the temperature of the reaction mixture at 45 to 50°. After all of the phenol has been added (rinse the beaker with 1 ml of water), shake the flask intermittently for 5 to 10 minutes while the contents cool to room temperature. Meanwhile, assemble the apparatus for steam distillation. Transfer the reaction mixture to a separatory funnel and drain the oily organic layer into a three-neck 500-ml flask. Add 150 ml of water and then carry out steam distillation until no further o-nitrophenol appears in the distillate. Collect the o-nitrophenol, air dry, and determine yield and melting point. For isolation of the para isomer, adjust the total volume of the distillation residue to about 200 ml by adding more water or removing water by distillation. Decant the hot mixture through a coarse fluted filter or loose cotton pad, add about 1 to 2 g of charcoal to the hot filtrate, heat again to boiling, and refilter to remove charcoal. Cool a 500-ml Erlenmeyer flask in ice and pour into it a small portion of the hot solution to promote rapid crystallization and prevent separation of the product as an oil. Then add the remainder of the solution in small portions so that each is quickly chilled. Collect crystals, dry, and report yield and melting point.

  • Molarity of the water.

    どなたか簡単な質問で余計答えるのが難しいかもしれませんが助けていただけないでしょうか?  Explain why the molarity of a dilute aqueous solution (e.g. 1mM acetic acid at pH7) is essentially the same as for water. 数式や英語、日本語何を使っていただいてもかまいません。 どうかよろしくお願いします。 ps molarity (mol/liter) of water is 55.5Mです。

  • 英文(数学?)の問題がわかりません

    The anticipated income from an investment is $40000 per year for the first 5 years and $30000 per year for the remaining 5 years of life. The desired rate of return on the investment is 12 percent. The salvage value at the end of 10 years is expected to be 20 percent of the first cost. Determine the first cost that will result in the 12 percent return. Ans.:$219,700 考え方と途中式をお願い致します。

  • 化学分析について助言を頂けますか。

    現在、欧州薬局方に収載されているCPD液の定量試験(ブドウ糖)を実施しよとしています。 (CPD液とは、クエン酸(無水):0.327g、クエン酸ナトリウム(二水):2.63g、リン酸二水素ナトリウム(一水):0.222g、ブドウ糖(無水):2.32gの4成分に精製水を加えて100mLとした液です。) 欧州薬局法の文面は以下になります。作業的には、できるのですが、結果が25.0g/Lになります。(23.2になるはずですが。)化学分析に詳しい方、どこを注意した方がよいなど助言を頂けませんか?宜しくお願い致します。なお日本語にした質問を同じカテゴリに入れますので拝見頂けますか。 Reducing sugars Dilute 5.0 ml to 100.0 ml with water R. Introduce 25.0 ml of the solution in to a 250 ml conical flask with ground-glass neck and add 25.0 ml of cupri-citric solution R1. Add a few pieces of porous material, attach a reflux condenser , heat so that boiling begins within 2 min and boil for exactly 10 min. Cool and add 3 g of potassium iodide R dissolved in 3 ml of water R. Add 25 ml of a 25 per cent m/m solution of sulphuric acid R with caution and in small quantities. Titrate with 0.1 M sodium thiosulphate using 0.5 ml of starch solution R, added towards the end of the titration, as indicator (n1 ml). Carry out a blank titration using 25.0 ml of water R (n2 ml). Calculate the content of reducing sugars as anhydrous glucose or as glucose monohydrate, as appropriate, from the Table 0209.-1. table0209.-1 Volume of 0.1M ____Anhydrous glucose sodium thiosulfate___ in milligrams (n2-n1 mL) 8 ____ ____ ____19.8 9 ____ ____ ____22.4 10 ____ ____ ____25.0 11 ____ ____ ____27.6 12 ____ ____ ____30.3 13 ____ ____ ____33.0 14 ____ ____ ____35.7 15 ____ ____ ____38.3 16 ____ ____ ____41.3 日本語に訳すと、こうなります。 本品5.0mLを正確に量り、水を加えて正確に100.0mLとする。この液25.0mLを正確に250mLコニカルビーカーに取り、クエン酸第二銅溶液25.0mLを加える。少量の沸騰石を加え、還流濃縮器を取り付け、沸騰させる為に2分間熱し、その後、10分間煮沸する。冷後、ヨウ化カリウム3gを水3mLに溶かした液を加え、25%硫酸溶液25mLを注意して加え、0.1mol/Lチオ硫酸ナトリウム液で滴定する(滴定値:n1)。(指示薬:0.5mLデンプン試液)同様に水25mLで空試験を行う(滴定値:n2)。 ブドウ糖含量(w/v%):以下の表より求める。 0.1mol/Lチオ硫酸    ブドウ糖量(mg) ナトリウム液滴定量    無水 (n2-n1、mL) 8 ____ ____ ____19.8 9 ____ ____ ____22.4 10 ____ ____ ____25.0 11 ____ ____ ____27.6 12 ____ ____ ____30.3 13 ____ ____ ____33.0 14 ____ ____ ____35.7 15 ____ ____ ____38.3 16 ____ ____ ____41.3

  • 英語の問題です

    A 175-lb woman stands on a vinyl floor wearing stiletto high-heel shoes. If the heel has dimensions shown, determine the average normal stress she exert on the floor and compare it with the average normal stress developed when a man having the same weight is wearing flat-heeled shoes. Assume the load is applied slowly, so that dynamic effects can be ignored. Also, assume the entire weight is supported only by the heel of one shoe. が物理の授業で出ましたが訳がまったく解りません。どなたか訳してください stressは応力でお願いしますm(_ _)m

  • 訳が分からない!!

    次の文の訳がうまく作れません。。 Many ecologists assume either that rates of gene flow are sufficiently high that populations across a species'range will respond similarly to the same environmental conditions or that rates of migration enable indivisuals to track changing abiotic factors. 少し生物学の専門的な用語が入っているので補足すると、 gene flow=遺伝子流動 population=個体群 species'range=種の生息域 といった感じです。 引っかかっているのは、population の前の that の働きです。おそらく either はそのあとの or と呼応していて、あとの2つの that は「~ということ」となり assume の目的語になると思うのですが。。その that が何なのかがちょっと。。 よろしくお願いします!

  • この文章の和訳をお願いします。

                     2. Adopted assumptions and basic equations We consider two planetesimals revolving around the proto-Sun (being called the Sun). Here we assume that the mass of the one of these, which hereafter is called a protoplanet or simply a planet, is much larger than that of the other (being called a particle). We also assume that the planet moves circularly around the Sun without the influence of gravity of the particle. Furthermore, each orbit of the particle is limited in the ecliptic plane of the planetary orbit. Under these assumptions, the particle motion is simply given by a solution to the plane circular RTB problem. よろしくお願いします。