catalyst 2950G catOS 動作確認について
この度、catalyst 2950Gを購入致しました。
IOSだと思っておりましたが、catOSが入っておりました。
catOSの知識がないため、動作確認が出来ません。
保証期間は1週間のため、良品か不良かの判断だけでも付けたく、有識者の方ご判断頂けますでしょうか？
また、上記の機器にIOSを入れることは可能でしょうか？
よろしくお願いします。
00.573983: Please set IPAddr variable
0:00.574567: Please set Netmask variable
0:00.574924: Please set Broadcast variable
0:00.575288: No gateway has been specified
0:00.575780: Network is not configured
WS-C2948G bootrom version 6.1(4), built on 2001.07.30 14:43:26
H/W Revisions: Fin: 2 Head: 11 Board: 1
Supervisor MAC addresses: 00:08:a4:c2:f0:00 through 00:08:a4:c2:f3:ff (1024 addresses)
Installed memory: 64 MB
Testing LEDs.... done!
The system will autoboot in 5 seconds.
Type control-C to prevent autobooting.
rommon 1 >
The system will now begin autobooting.
Autobooting image: "bootflash:cat4000.6-3-3.bin"
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC################################
Starting Off-line Diagnostics
Mapping in TempFs
Board type is WS-X2948
DiagBootMode value is "post"
Loading diagnostics...
Power-on-self-test for Module 1: WS-X2948
Status: (. = Pass, F = Fail)
processor: . cpu sdram: . eprom: .
nvram: . flash: . enet console port: .
switch registers: . switch sram: .
Module 1 Passed
Exiting Off-line Diagnostics
IP address for Catalyst not configured
DHCP/BOOTP will commence after the ports are online
Ports are coming online ...
Cisco Systems, Inc. Console
Enter password:
2009 Oct 28 10:09:06 %SYS-5-MOD_OK:Module 1 is online
2009 Oct 28 10:09:14 %SYS-5-MOD_OK:Module 2 is online
Console> en
Enter password:
Console> (enable) sh conf
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default configurations.
...........
..
begin
!
# ***** NON-DEFAULT CONFIGURATION *****
!
!
#time: Wed Oct 28 2009, 10:09:42
!
#version 6.3(3)
!
!
#system web interface version(s)
!
#test
!
#frame distribution method
set port channel all distribution mac both
!
#ip
set interface sl0 down
set interface me1 down
!
#spantree
#vlan <VlanId>
!
#syslog
set logging level cops 2 default
!
#set boot command
set boot config-register 0x2
set boot system flash bootflash:cat4000.6-3-3.bin
!
#module 1 : 0-port Switching Supervisor
!
#module 2 : 50-port 10/100/1000 Ethernet
end
Console> (enable) sh ver
WS-C2948 Software, Version NmpSW: 6.3(3)
Copyright (c) 1995-2001 by Cisco Systems, Inc.
NMP S/W compiled on Oct 30 2001, 11:07:05
GSP S/W compiled on Oct 29 2001, 15:11:40
System Bootstrap Version: 6.1(4)
Hardware Version: 2.5 Model: WS-C2948 Serial #: JAE060401J4
Mod Port Model Serial # Versions
--- ---- ---------- -------------------- ---------------------------------
1 0 WS-X2948 JAE060401J4 Hw : 2.5
Gsp: 6.3(3.0)
Nmp: 6.3(3)
2 50 WS-C2948G JAE060401J4 Hw : 2.5
DRAM FLASH NVRAM
Module Total Used Free Total Used Free Total Used Free
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
1 65536K 30952K 34584K 12288K 5170K 7118K 480K 167K 313K
Uptime is 0 day, 0 hour, 1 minute
Console> (enable)
